Cecilware BC1 Especificaciones descargar pdf (Pagina 2)

INSTALLATION AND OPERATING INSTRUCTIONS

Warranty is void if the Brewer is connected to any voltage other than voltage specified on the data label of the

Brewer.

UNPACKING AND INSPECTION

Carefully unpack the Brewer by cutting the straps and lifting the sleeve carton off the Brewer.

ASSEMBLY AND SET-UP

The Brewer is shipped complete with:

DESCRIPTION BC1,120,240,301 BC2,302

Adjustable legs 4 4

Carriers complete with

Faucets and Covers

1 2

Funnels with wire baskets and

sample filter pack

1 2

Remove carriers from Brewer, one has the four (4) legs packed inside. Install legs by tilting Brewer on it's back and

screwing the legs into the threaded leg support openings on bottom.

WATER HOOK UP

The National Sanitation Foundation (NSF) requires the following for the NSF approved installation:

1. A quick disconnect water connection or enough extra coiled tubing (at least 2x the depth of the unit) so that the

Brewer can be moved for cleaning underneath.

2. An approved flow-back prevention device such as a double check valve to be installed between Brewer and water

supply.

WATER CONNECTION

The Brewer comes equipped with a 3/8 compression water inlet fitting located in the back. Use a 3/8 diameter copper

tubing to connect the Brewer to a cold water supply, water pressure should be 20 psi min. to 80 psi max. An external

shut-off valve and a water filtering system with a charcoal filter is highly recommended.

ELECTRICAL CONNECTIONS

A terminal block inside the base compartment is provided for electrical connections. Two (2)

/l6" diameter

openings for field conduit connections are provided in the bottom and the back of the base.

To access the Terminal Block, loosen the 2 screws on the side of the base cover and remove the 1 lower screw at the

base of the rear panel. Dis -engage base panel from rear panel by lifting base panel up and lifting back towards rear

panel.

RECOMMENDED WIRING SIZES

Model No. Single

(1) Phase

BC1, BC120, BC240, BC301

BC2, BC302

12 AWG

10 AWG

Note:

1. Neutral (N) and Ground Wires to be 14 AWG minimum.

2. Field wiring must be suitable for 75° C.

3. Use Copper wire only for all power supply connections.

INITIAL PRIMING - Filling of Tank

The BC Brewers are shipped with the Thermostat in the OFF position. Do not turn Thermostat to the ON position until

the Brewer has been fully primed.

1. Turn water supply on and check for leaks at the water inlet connections. Tighten compression

fitting if necessary.

2. Turn on power to the Brewer. The Brewer will automatically start filling. After 6 minutes the filling cycle will stop

and the thermostat should be turned clockwise to the full ON position. Allow

1 2 3 4 5 6 7 ... 15 16

Comentarios a estos manuales

Sin comentarios

Cecilware BC1 Especificaciones Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Cafeteras Cecilware BC1